MTRS Stereo Amplifier
EMM Labs is proud to present its latest innovation in audio technology: the MTRS Stereo Amplifier. The MTRS is a 400W Stereo Class A/B solid-state amplifier.
The MTRS is able to drive the most severe loads with no overall feedback, using Ed's completely re-designed high current Meitner Power Driver. The MTRS can handle any speaker load with ease, delivering high power, low distortion and wide bandwidth.
The MTRS also incorporates::
- A new proprietary power system
- Fully discrete circuits
- Fully balanced audio paths throughout
- Our custom ceramic PCB boards
- Real time protection to avoid speaker and amplifier damage
The MTRS has been meticulously designed, from its short and fully balanced audio paths throughout, to its proprietary power systems and beautifully finished chassis.
The MTRS is completely stable driving difficult, complex loads, and has the uncanny ability to drive low impedance speakers down to an Ohm! All while keeping distortion at miniscule levels.
The MTRS is the ultimate amplifier for those who demand the best in audio reproduction in a stereo package.
Just like our reference MTRX and MTRX2 amplifiers, the MTRS Stereo Amplifier is designed, manufactured, and built in Canada with no compromise.
Click for a list of official EMM Labs and Meitner Audio representatives near you.
Click to go back to the main EMM Labs page.
Specifications
Power/Channel into 4Ω:
400W Dynamic (RS-490 EIA)
330W RMS Continuous
Voltage Gain: 30dB
Frequency Response: 0.1Hz - 200kHz (Full Rated Power)
Signal to Noise: Greater than 120dB (A Weighted)
THD+N : Less than 0.01% (20Hz-20kHz, Full Rated Power)
IMD: Less than 0.01% (20Hz-20kHz, Full Rated Power)
Slew Rate: Greater than 100V/μS
Damping Factor: Greater than 200
Inputs:
Left and Right Balanced (XLR)
Left and Right Un-balanced (RCA)
Input impedance:
100kΩ Balanced (XLR)
47kΩ Un-balanced (RCA)
Outputs:
Left and Right Sets of Furutech Binding Posts
System:
RS-232 Communication Port
Power & Accessories:
100/115/240V, 50/60Hz (Factory Set)
30A 250V 3-pin, IP44, IEC60309 type power inlet
Custom Kimber Kable 30A Power Cable
Custom EMM Labs Flight Case
Amplifier Dimensions (WxDxH): 544 x 584 x 297 mm
Amplifier Weight: 82kg
Finish:
Silver and Black Ultrafine CNC Precision Finish. Black insert and power button
Support and Downloads
For general support and upgrades please contact your local EMM Labs dealer/distributor.
For all other support issues please contact EMM Labs support directly by filling out our website support form located at the bottom of this page. Please include your name, email address, product name and serial number plus a brief description of the issue. Our staff will get back to you shortly.
Click on the links below to download documents and software: